Byron to move forward with Gulf of Mexico development after making ‘substantial’ discovery

Byron Energy has confirmed substantial hydrocarbon column at its SM58 011 well on the Cutthroat prospect in the Gulf of Mexico. Byron will now move forward with the development of SM58 block. 

Enterprise 263, formerly known as Hercules 263. Source: Enterprise Offshore

Byron said in a statement on Thursday that porosity logs and mud gas isotope samples have been acquired and analysed across the O Sand in the SM58 011 well.

Byron reported earlier in August that the the SM58 011 well had been drilled to a depth of 10,885 feet Measured Depth (MD) equivalent to 9,832 feet True Vertical Depth (TVD) to test the Cutthroat prospect.

The company said that a Quad-combo suite of Electric, Porosity, and Sonic logs were obtained in the well bore by running Measurement After Drilling logs (MADPASS) in the past 24 hours. Third party petrophysical calculations indicate 302 feet of gross hydrocarbon bearing O Sands with 271 feet of net True Vertical Thickness (TVT) were logged in the well bore with the package filled to base.

According to the company, the logs confirm a thick, clean, high quality O Sand with average porosity above 30 percent. The SM58 011 well has logged the thickest O Sand hydrocarbon column within the entire SM73 field in which over 350 wells have been drilled.

Analysis of mud gas Isotope samples indicate the hydrocarbon is a liquids rich gas with high quality oil, typical of O Sand completions on the block. The isotope analysis indicates that the hydrocarbons in the SM58 011 well are from the same source rock as hydrocarbons produced from the Byron operated SM71 F platform where the stratigraphic equivalent D5 Sand has now produced over 1.5 million barrels of high-quality oil and 2.5 billion cubic feet of gas.

Final liquids content of the O Sand will not be fully known until the well is completed and placed into production but are expected to range from 30 —100 bbls of oil per million cubic feet of gas. Based on nearby well control and the fact the SM58 011 well is drilled high on structure, it is likely that there is a downdip oil leg and if so, it will be produced in the SM58 011 well later in its life.

The company expects that third party reserves for the SM58 011 well will be released in mid-September along with the company’s annual reserve report.

The O Sand has produced 11.6 million barrels of oil and 26.3 billion cubic feet of gas from 10 completions in the adjacent area immediately to the west of the Cutthroat prospect. The stratigraphic equivalent D5 Sand has produced over 22 mmbo and 17.5 Bcfg in the SM73 Field to date.

 

Byron moving forward with development

 

Byron said it will now move forward with the development of SM58. Initial engineering studies on structural modifications to the jacket and decks have been completed in order to fast track construction on a recently acquired platform.

Work has begun to remove existing production equipment from the platform for refurbishment. The facility is being redesigned to accommodate up to 8,000 barrels of oil per day, 80 million cubic feet of gas per day and 8,000 barrels of water per day. Pipeline design and route surveying is also underway.

Current operations at 5 PM August 28, 2019, are preparing to run 7 5 /8″ casing to the bottom of the well before drilling ahead to the planned total depth of 11,466 feet MD (10,418 feet ND). This lower portion of the well bore will test one additional seismic amplitude in the lower O Sand section.

Byron’s Cutthroat Prospect was identified and evaluated using high-tech Reverse Time Migration (RTM), Vector Image Processing (VIP) and Full Waveform Inversion (FWI) 3D seismic processing. Those datasets together revealed an undrilled trap designated the Cutthroat prospect within the central portion of SM58 that lies at the same structural depth as several oil wells immediately to the west.

The Cutthroat prospect area was not defined by older seismic processing versions, but was imaged through careful reprocessing by WesternGeco, a Schlumberger company. Byron has identified several other drilling opportunities on the SM58 block using the same dataset.

Byron holds all the operator’s rights, title, and interest in and to the SM58 Lease Block to a depth of 13,639 ft. subsea with 100% Working Interest (WI) and 83.33% Net Revenue Interest (NRI). To date, all identified drilling opportunities on the SM58 lease are above 13,639 feet subsea. Below 13,639 feet subsea, Byron has a 50% WI (41.67% NRI) under a pre-existing exploration agreement. Additionally, Byron owns a non-operated 53% WI (44.165% NRI) in the associated existing producing assets being the SM69 E Platform and SM58 El wellbore.

Bryon’s CEO, Maynard Smith, commented: “This is obviously a fantastic result for Byron and will lead to substantial growth over the next few years.”


Spotted a typo? Have something more to add to the story? Maybe a nice photo? Contact our editorial team via email.

Also, if you’re interested in showcasing your company, product or technology on Offshore Energy Today, please contact us via our advertising form where you can also see our media kit.

Share this article

Follow Offshore Energy Today

Events>

<< Oct 2019 >>
MTWTFSS
30 1 2 3 4 5 6
7 8 9 10 11 12 13
14 15 16 17 18 19 20
21 22 23 24 25 26 27
28 29 30 31 1 2 3

Executive Oil Conference & Expo 2019

Executive Oil Conference and Exhibition is a unique opportunity to meet with all of the region’s…

read more >

Oil & Gas Vietnam 2019

Oil & Gas Vietnam (OGAV) 2019 is the only specialized oil & gas event in Vietnam that brings together an international congregation of both upstream and downstream oil and gas companies and also its supporting industries gathered in the heart of Vietnam’s oil and gas industry in Vung Tau, to showcase the latest developments in the oil and gas industry.

read more >

Jobs>

Looking to fill a job opening?

By advertising your job here, on the homepage of OffshoreEnergyToday.com, you'll reach countless professionals in the sector. For more information, click below...

apply

Looking to fill a job opening?

By advertising your job here, on the homepage of OffshoreEnergyToday.com, you'll reach countless professionals in the sector. For more information, click below...

apply