Centec Introduces UROS-CT Centralizer

Centek Group, the leading centralizer manufacturer, has introduced its UROS-CT centralizer targeted on tight casing applications in deep water wells.

UROS-CT

The UROS-CT is designed for use in tight tolerance casings where the centralizer is required to compress fully to travel between tight casing strings yet will expand to the designed open hole size. The UROS-CT is engineered to precise ring-gauge tolerances, partly because casing drift downhole is a major concern when running deep water wells, but also because the centralizer must compress as closely as possible to the casing as every millimeter saved allows for greater expansion in the open hole.

The other problem with tight casing strings is securing the centralizer in position. Bolt-on stop collars are too proud of the casing so Centek uses low-profile, positive stop-rings.

The UROS-CT fits straight on to standard casing joints, so there is no need to run an expensive pup joint and substantial rig make-up time is avoided. This centralizer significantly reduces insertion forces and drag, and the unit does not need to be pulled into the well as the design allows for normal run-in-hole (RIH) methods, so it goes down under its own mass.

Standoff is key to success once in the open hole and the UROS-CT provides the highest levels of standoff, better well clean-out during well conditioning, and improved cement displacement to ensure good zonal isolation as well as minimizing corrosion later in the life of the well.

“The UROS-CT is being used at various water depths from 5,000 feet and beyond. With spread costs for a drill ship equating to roughly $700 per minute, avoiding problems on RIH is of paramount importance, as is saving make-up time at the surface. Providing the right quality tool for the job is one our primary goals” said Cliff Berry, Vice-President, Global Business Development at Centek Group. “In deep water wells you may have up to nine strings running through each other so the tolerances are incredibly tight therefore a tool to maximize the cement job is of vital importance.”

The UROS-CT is being run successfully off Norway, Brasil, Brunei, and Malaysia, and is now being used in the Gulf of Mexico by both US and Mexican operators.

Source: Centec, November 22, 2013

 

 

Share this article

Follow Offshore Energy Today

Events>

<< Jul 2019 >>
MTWTFSS
1 2 3 4 5 6 7
8 9 10 11 12 13 14
15 16 17 18 19 20 21
22 23 24 25 26 27 28
29 30 31 1 2 3 4

Uganda International Oil and Gas Summit 2019

Uganda International Oil & Gas Summit will once again examine the industry’s developments…

read more >

8th OIL & GAS AFRICA 2019 CONFERENCE

OIL & GAS AFRICA is one of the most prime regional & international Oil and Gas conferences in East Africa…

read more >

Gas Indonesia Summit 2019

Gas Indonesia Summit & Exhibition is returning for the fourth edition in Jakarta…

read more >

Shanghai Int Petrochemical and Offshore Oil & Gas and Chemical Industry Technology and Equipment Exhibition 2019

cippe Shanghai has attracts both…

read more >

Jobs>

Looking to fill a job opening?

By advertising your job here, on the homepage of OffshoreEnergyToday.com, you'll reach countless professionals in the sector. For more information, click below...

apply

Looking to fill a job opening?

By advertising your job here, on the homepage of OffshoreEnergyToday.com, you'll reach countless professionals in the sector. For more information, click below...

apply

Looking to fill a job opening?

By advertising your job here, on the homepage of OffshoreEnergyToday.com, you'll reach countless professionals in the sector. For more information, click below...

apply